Does the granulator not discharge? Is production affected over time?

 

　　

A few days ago, a farmer left a message to the author, asking, "why does the feed granulator feel less durable after being used for a period of time?" Production feels lower than before, even unexpected. Is that why? "To this end, the author summarizes the following points to see if you have the same situation. Let's discuss:

 

1. Blockage of feed inlet and die hole of feed granulator may reduce the working efficiency of feed granulator

 

If your feed granulator has low output or no discharge, you can check whether the feed inlet and screen of the feed granulator are blocked. Generally speaking, the feeding port of the flat die pelletizer is vertical, so if it is blocked, it can be seen directly. However, for the ring mold feed granulator, although it is equipped with a forced feeder, it may also cause feed blockage in the narrow regulator.

 

The same is true of die hole plugging. Once the die hole is blocked, it's easy to clean it up a little. If the blocking area is large, it's troublesome. Therefore, we suggest that before using the feed granulator, oil should be used to pass through the feed granulator to ensure lubrication, and oil should be used to pass through the feed granulator before the granulation work is completed to prevent die hole blockage.

 

2. The influence of feed materials on the output of feed granulator

 

As we all know, feed pellet machine is a kind of dry in dry out feed machine. If the moisture content in the raw material is high, it will not form particles. If the water content is too small, it is difficult to press together to form particles. Generally speaking, we require that the moisture content of feed materials should not exceed 12 points during granulation. If the material is too dry, we can use auxiliary equipment such as air conditioning.

 

3. The gap between the pressing roller and the ring mold of the feed granulator is not suitable, which leads to the low output of the feed granulator

 

In feed machinery, some accessories will be worn after long-term use, such as the hammer of feed grinder and the pressure roller of feed granulator. In the process of long-term backlog of feed, it will inevitably wear. At this time, it is necessary to check whether the inner side of the ring mold and the pressing roller are worn to determine the reason for the low output of the feed granulator.

 

4. Low voltage may also lead to the output of feed granulator

 

General farmers are located in remote areas with a certain distance from the village, and the voltage used may be unstable. Therefore, if the above possibility is ruled out, granulation can be carried out outside the peak period of power consumption to observe the effect. If the feeding speed is slow and the pelleting speed is fast, it can be adjusted appropriately. You can also contact the manufacturer of the purchased feed pelleting machine to answer questions.